EKN Platinum Forum - Russell
HOME - NEWS - FEATURES - DRIVERS - PR WIRE - FORUMS - MULTIMEDIA - PHOTOS - SCHEDULES - RESULTS - LINKS - INTERNATIONAL NEWS - NEW TO KARTING - CONTACT


 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Login to check your private messagesLogin to check your private messages   LoginLogin 
CC same spot but sniper says im off

 
Post new topic   Reply to topic    EKNClassic.com Forum Index -> Chassis & Handling
View previous topic :: View next topic  
Author Message
marc-andre hubert



Joined: 10 Apr 2012
Posts: 239

PostPosted: Fri Jun 21, 2013 3:12 am    Post subject: CC same spot but sniper says im off Reply with quote

I know it means chassis is bent, but I scalled it and got front back to about 2lbs from side to side, wich I had but Dot facing forward on both, then I put Sniper laser on it and one side shows way too much camber.. so now Dots are facing difference direction but camber is where I want it both side, Toe is good and even with Ruler in front and turning wheels to see castor is even? whats going on, .
Back to top
View user's profile Send private message Visit poster's website
Steve Moody



Joined: 16 Nov 2004
Posts: 39
Location: United States, Oregon, Portland

PostPosted: Sat Jun 22, 2013 9:25 am    Post subject: Reply with quote

Bent spindle?
Back to top
View user's profile Send private message
patrick slattery



Joined: 23 Apr 2004
Posts: 794
Location: United States, Ohio, cleves

PostPosted: Sun Jun 23, 2013 4:20 pm    Post subject: Reply with quote

Or Kingpin
Back to top
View user's profile Send private message
marc-andre hubert



Joined: 10 Apr 2012
Posts: 239

PostPosted: Mon Jun 24, 2013 2:52 am    Post subject: Reply with quote

took whole spindle assembly off, kingpin bolt was bent, and then measured angles from spindle was also slightly bent, bent it back a lot better.
Back to top
View user's profile Send private message Visit poster's website
Display posts from previous:   
Post new topic   Reply to topic    EKNClassic.com Forum Index -> Chassis & Handling All times are GMT - 8 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Go Top
Copyright © 2002 - 2018 Ekartingnews.com. All Rights Reserved.
DB time: 0.24976 (79.71%), total time:0.313332, queries:20